Dear all
i want to know about the system connection (like input output cable) from pangolin hardware (such as QM2000 PCI, QM2000.NET, FB3) to GrandMA2.
in here i use QM2000 PCI bus, QM2000.NET and cable use CAT6.
For the installation, i connect the PC to HUB using CAT6 cable than from HUB to GrandMA PC console using CAT6 cable and using ArtNet too.
The IP for laser computer i used 192.168.1.xxx (xxx is serial my QM2000 card or QM2000.NET) and for GrandMA PC IP i use 192.168.1.5 and ArtNet using IP 192.168.2, and for the all subnet i put 255.255.255.0
For laser software i use LD2000 and Beyond.
After i install it, i patch the pangolin library on MA PC console using the GrandMA definition file from pangolin download.
After patch on MA PC, i set the Beyond from PC to set up the DMX universe using ArtNet than DMX ArtNet Monitor.
Unfortunatelly, that system can not run. On my Beyond on my pc that is no input DMX show from DMX Monitor.
For the question, what is wrong with that? that anyone know for the solutions? Or does any one in here ever try or practice using that?
Thank u and warm regards