How to Create a Laser Circle for a Wedding First Dance?

F

firesteve

New Member
I've seen this trend where a couple dances inside a laser-projected circle during their wedding first dance, and I'd love to learn how to do this with my own laser setup. I have 2x Clubmax 3000 FB4. Does QuickShow already have a pre-made circle in the cloud library that I can use, or should I create one from scratch?

Are there any tutorials or guides available for creating this specific effect?

Screenshot.png
 
Hello, I am actively doing this job in Turkey. You need a truss or a high ground to get an angle. After the installation, you can get this image using the geometric symbols from the "Classic Statics" page. Of course, don't forget to make your zone settings!!!
 
There is no need to reduce the laser output. After making a safe zone adjustment from the "Projector settings" or "Projector zones" settings, you can run it at full power. Since the bride and groom will be inside the circle, there is no danger. I did it with a maximum 30 watt laser.
 
I would certainly advise the brides couple and everyone else involved, Not to look into the laser. That will most certainly permanently damage their retinas. I would also watch out with 30 watts on such short distances. It can certainly cause damage. It all depends on beam quality and distance. Use the correct haze and you do not need that much power.
 
Bob@Pangolin said:
I would certainly advise the brides couple and everyone else involved, Not to look into the laser. That will most certainly permanently damage their retinas. I would also watch out with 30 watts on such short distances. It can certainly cause damage. It all depends on beam quality and distance. Use the correct haze and you do not need that much power.
Click to expand...
Of course, since the laser is a powerful device, the first priority should always be human health and the next step should be camera lens safety.
 
You must log in or register to reply here.
Back
Top