Help！Regarding the stitching of images into a large picture

[jujun]

I have 6 lasers and need to assemble them into a complete image from left to right.
After setting up the 'also to...' function in Beyond, its projection area is stretched six times. So, how can I make animation materials to adapt to this projection area without deformation?
In the program grid, I know that it is possible to shorten the X-axis size of a certain grid's animation material (similar to the ostrich running in place in the program grid) to adapt, but for materials that require full screen (eagles flying from left to right), how can I set it to full screen?
Thanks!

 

[a1laserboy]

I think you forgot to setup the window and resize processing. Make a new 'also to' zone, set each of your output zones area, block output from the also to zone. Then send your content to that zone.

 

[jujun]

I think you forgot to setup the window and resize processing. Make a new 'also to' zone, set each of your output zones area, block output from the also to zone. Then send your content to that zone.

As shown in the attachment: I need to use 6 laser lights to assemble a complete image on a 15:1 wall. When I use the 'also to...' function, its screen is still widened.

 

[jujun]

I think you forgot to setup the window and resize processing. Make a new 'also to' zone, set each of your output zones area, block output from the also to zone. Then send your content to that zone.

 

[a1laserboy]

In my experience, as long as you split the output to each zone evenly and all projectors are outputting the same size, it should work fine. I see that you are using a visualiser. Perhaps something isn’t right there. If you look at the laser preview in beyond and output a grid to the also to zone, is the scale correct across the zones?

 

[a1laserboy]

This is what happens if your projectors are simply 6 in a row with square outputs and evenly set also to settings. If you want your image to scale correctly, in this case, it's width needs to be about 16.6%.
Here are each zones also to parameters as I saw your first one was slightly off, maybe your others are too
1: -100 -66.66
2: -66.66 -33.33
3: -33.33 0
4: 0 33.33
5: 33.33 66.66
6: 66.66 100