2 Projectors on a Single fb3, but X-Axis squished.

[BradG]

Hi all. I am having an issue with 2 laser projectors using a single fb3.

The issue is when the projectors are displaying, the 2nd projector (at the end of the daisy chain) has its X-axis squashed by approximately 50%.

The setup is 2x lw 2000RGB projectors, and a single fb3 from my laptop. They are daisy chained together with ilda cables.

In the attached image you will notice that the 2nd projector has its x-axis flipped. This was simply done with the switch on the back of the 2nd lw 2000RGB.

Does anyone have any suggestions?

Thanks for any help

 

[Stingray]

Hi,
is there the same problem if you don´t use the x-axis-flip-switch?

 

[Bob@Pangolin]

Did you already try another ilda cable?

 

[BradG]

Hi,
is there the same problem if you don´t use the x-axis-flip-switch?

Yes. Sorry i should have mentioned that.
Thanks

 

[BradG]

Did you already try another ilda cable?

Hi Bob.
I did try mixing the two ilda cables i have back and forth.
I will further investigate this will a new cable in the morning and get back to you.

Thanks!