Beyond from GrandMA onpc

Discussion in 'Lasershow Designer BEYOND' started by likelvin87, Nov 14, 2018.

  1. likelvin87

    likelvin87 Member

    Help needed urgently!

    Anybody can guide me step by step for the network control from GrandMA to Beyond 3.0?

    Cant't seem to get the artnet connected and i'm using QM2000 as my master . and the rest of the projectors on fb4s.

    Thanks
     
  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    You probably need the information that is in this vid:

     
    Last edited: Nov 15, 2018
  3. Bob@Pangolin

    Bob@Pangolin Staff Member

    Make sure you use IP range 2.x.x.x ! as this is a requirement from GrandMA
     
  4. likelvin87

    likelvin87 Member

    Thanks Bob, But if im using qm2000 pro to be my master to use the ultimate version, which requires the IP to be in 192.168.1.XX. The moment i change the IP to 2.X.X.X , my QM get disconnected. so how do i overcome this?
     
  5. Bob@Pangolin

    Bob@Pangolin Staff Member

    Probably the easiest way is to open this tool : C:\LD2000\Network\QM2000NET_Config.exe. and change the ip of the card.
     
  6. likelvin87

    likelvin87 Member

    Hey Bob, thanks for the advice. I configured the QM2K pro card and accidentally made a mistake with the IP add. Now i can't detect the card at all. How do i restore the IP of the card ?
    I change the IP of the QM to 2.2.1.1 . I use the same IP on the network adapter but couldn't detect. Need your help urgently.
     
  7. Bob@Pangolin

    Bob@Pangolin Staff Member

    Try to set the pc to 2.2.1.3, and then search for the card
     
  8. likelvin87

    likelvin87 Member

    Thanks alot Bob, it worked for me !