Can't start ld2000

Discussion in 'Lasershow Designer 2000' started by ArtLasers, Jul 10, 2012.

  1. ArtLasers

    ArtLasers Member

    Hello! I installed ld2000 to notebook with win7 x86, but when I start it, I get -1003 error. Qm2000.net
    I think that problem is with new hardware of notebook.
    I think that notebook have another protocol to initiate PCI PCB's.
    Can you halp me to configure my ld2000 to start without initiate pci and init only NET interface?
     
  2. ArtLasers

    ArtLasers Member

    UP. Chipset is Intel® HM65
     
  3. Aaron@Pangolin

    [email protected] Staff Member

    That is one of the errors that indicate LD2000 cannot find a connected QM2000. Can you advise if your IP settings are correct (192.168.1.xxx)?
     
  4. ArtLasers

    ArtLasers Member

    Ld2000 give error message momentaly. It not try to connect..
     
  5. Aaron@Pangolin

    [email protected] Staff Member

    Can you advise if your IP settings are correct (192.168.1.xxx)?
     
  6. Cyberb0b

    Cyberb0b Well-Known Member

    Your problem likely is in your network configuration.
    Are the network addresses setup correctly?
     
  7. ArtLasers

    ArtLasers Member

    I have another PC with ld2000 and ld2000network enabled in my network. it IP is 192.168.0.4. From another Win7PC I connect without problem.
    I find some idea:
    And I see "InitialQMCheck"
     
  8. ArtLasers

    ArtLasers Member

    Up. I can give you access to my notebook via internet.
     
  9. Aaron@Pangolin

    [email protected] Staff Member

    I would be glad to check your computer remotely; just call into our office between 10am and 4pm EST and I will set up a "go to assist" session.
     
  10. ArtLasers

    ArtLasers Member

    I can't call. My English is bad for call. Can I communicate with you via Skype messages,ICQ,WhatsApp?
     
  11. Stuka

    Stuka Well-Known Member

    Same issue -resolved... : )

    What version of the Pangolin software are you running?

    I recently experienced the same issue after installing my LD2000 suite on Windows 7 64-bit, using my original Pangolin disk set.

    Once I downloaded and installed the latest version of the LD2000 software update from the Pangolin web site, eveything worked fine! :)
     
  12. Aaron@Pangolin

    [email protected] Staff Member

    We don't have to communicate much on the call, I just want you to call so I can tell you what to do when I run the application to remote into your computer. I prefer the phone so we are not using any bandwidth that may be needed by the remote application.
     

Share This Page