Error messages time of error evenr

[lasershow-creation]

Hi Friends,

Is there any chance to see the time of an occured error event?
I have the problem currently, that for a long run installation the Ethernet connection is lost at a certain time over night, but I don’t know when this happens because there’s no time in the error event list. I can only see the disconnected controller error and the reconnection message.

If not yet implemented, I propose to implement this feature if possible?

Best regards,
Tobias

 

[Bob@Pangolin]

I am not sure what you are using, but I have time entries in the QuickLog

 

[lasershow-creation]

Hi Bob,
Thank you very much. I did not have have the QuickLog in mind. I was using the Notification Center all the while. But there’s no info about the events time…
QuickLog will be the choice for me now. Thank you.

Nevertheless, wouldn’t a time info be a good option for the Notification Center as well?