Fastest way to replace a projector?

lordGoldemort

lordGoldemort

Member
I always have a spare projector in case one fails. Now that they all have built-in FB4s (I used to have stand-alone FB3s) it won't simply be a case of plugging the replacement in. What's the fastest way of reassigning all the zones from the old projector to the new one?
 
Connect the new lasers, go over your zones, and change the assigned projector. Note that not every projector has the same projection area, so there can still be issues after replacing the projector. Make sure to test the replacement projector and make adjustments if necessary.
 
Bob@Pangolin said:
Connect the new lasers, go over your zones, and change the assigned projector. Note that not every projector has the same projection area, so there can still be issues after replacing the projector. Make sure to test the replacement projector and make adjustments if necessary.
Click to expand...
Would be nice if there was a dialog (or other UI element) for bulk zone reassignment! Could that be done in PangoScript?
 
You must log in or register to reply here.
Back
Top