FB4 DMX Output Settings

Discussion in 'Lasershow Designer BEYOND' started by aricha, Jan 20, 2016.

  1. aricha

    aricha Well-Known Member

    Hi
    How do I set FB4 DMX output?
    I can see that it is working on DMX monitor
    But I do not see the orange light on the FB4
     

    Attached Files:

    aricha, Jan 20, 2016
    #1
  2. ENOT

    ENOT Software Developer Staff Member

    Hi Aricha,

    What exactly you want to do? The question is not exact.

    Anyway, If you want control FB4 over DMX then you need to set Operation mode of FB4 on the display of controller. FB4 will disconnect from BEYOND and follow DMX commands.

    Best Regards,
    Alexey.
     
    ENOT, Jan 21, 2016
    #2
  3. aricha

    aricha Well-Known Member

    As I said I want to output DMX from the FB4.
    I want to control lights or smoke machines with Beyond and FB4
     
    aricha, Jan 21, 2016
    #3
  4. ENOT

    ENOT Software Developer Staff Member

    FB4 designed as embedded into projector controller. It has DMX IN and DMX THROUGH for sequential connection. There is no DMX OUT on FB4, at least currently. Recommended solution is ArtNet to DMX converter.

    Let me know if you have questions.

    Best Regards,
    Alexey
     
    ENOT, Jan 21, 2016
    #4
  5. aricha

    aricha Well-Known Member

    OK thank you.
    So if I want to output DMX from Beyond Enttec ODE is the solution?
     
    aricha, Jan 22, 2016
    #5
  6. ENOT

    ENOT Software Developer Staff Member

    Yes, ArtNet to DMX converter is an answer.
     
    ENOT, Jan 22, 2016
    #6
  7. Muhammad Shakeel

    Muhammad Shakeel New Member

    Hi, Can we Use Any artnet to DMX Device with Beyond in Output Settings ?
     
    Muhammad Shakeel, Apr 17, 2017
    #7
  8. Muhammad Shakeel

    Muhammad Shakeel New Member

    and how to add that artnet device ip in output settings ?
     
    Muhammad Shakeel, Apr 17, 2017
    #8
  9. aricha

    aricha Well-Known Member

    You can use the Enttec to out put DMX.
    Go Here and download the NMU.
    Once you installed it right click on the Icon and open it as administrator.
    Than you will be able to set the IP.
     
    aricha, Apr 17, 2017
    #9
    Bob@Pangolin likes this.

Share This Page