Alex Fischer
Active Member
I created several logos. Successfully. All logos do not have more than 1.000 points. They are mapped to a distributed zone with two lasers. All of a sudden, choosing some of the logos that worked very well before, the output stops and in the status line where all lasers are listed (buttom of beyond main window) on both lasers a '0' (zero) is displayed. This took about 30-45 seconds. During this time, no output is possible :-( ...
After this time, displaying some other logos is possible again. Others not. This is strange as I do not understand what the problem could be.
Additionally: after lasers stopped the output, I chose a different logo on a different page; from this time on the underline underneath the page name flashes for both (!) pages continuously and didn't stop anymore.
Any idea how I can troubleshoot this issue?
I'm using the most current version from Pangolin Beyond and I created the logos with Pangolin's advanced editor.
After this time, displaying some other logos is possible again. Others not. This is strange as I do not understand what the problem could be.
Additionally: after lasers stopped the output, I chose a different logo on a different page; from this time on the underline underneath the page name flashes for both (!) pages continuously and didn't stop anymore.
Any idea how I can troubleshoot this issue?
I'm using the most current version from Pangolin Beyond and I created the logos with Pangolin's advanced editor.