Projector Settings

[tecsdecs]

Hello

I am hoping someone can help me, I have been using quickshow with my laser and when I powered it all up today the preview was not available.

I have tried several different things to get it back but have not managed to do it.

In Projector Settings I am seeing an information message 'This projector can not yet display a test pattern because projection zones have not yet been assigned.

I never did this when I set this up and have uninstalled and reinstalled it but still nothing.

Please could somebody tell me what I am doing wrong.

Thanks

 

[Aaron@Pangolin]

Take a look at our Zones overview, https://www.youtube.com/watch?v=1OjDRpIlfM0, this might help you understand what you need to set up.

I suspect you just need to verify you do not have any demo projectors within the hardware controllers list and verify your graphic and atmospheric zones are going to your installed FB3 hardware controller.