Gotic Laser
New Member
I work with Quick Show 5.5.0 and 3 pcs. FB4SE in my lasers along with Akai APC mini midi controller.
However, I noticed some problems.
In the Dynamics section I set Soft pause duration but only a quarter (maybe even less) of the Cues respond to this function. Then, the same Cues that do not respond to Soft pause duration - don't respond neither to the Animation speed value, too.
Such Cues run at the same speed regardless of the animation speed value, only they stop when the Animation speed value is 0.
I am unable to force them to slow down or speed up beyond the default Cue speed.
I noticed another interesting thing - the same Cues that in Live Control will not respond to the Animation speed value - as soon as I open the Shape editor, Advanced image synthesizer or Edit Frame/Animation (depending on the type of Cue) - at the same moment the Animation speed control are re-established, everything go perfect (?!)
To repeat, some other Cues behave quite normally in Live mode as well.
I don't know if this is some software error in my system or it is simply impossible to set the vast majority of Cues to respond smoothly to the Animation speed in Quick Show.
Given that I spent a lot of time setting up a proper Quick Show setup for my needs, I would be very grateful if someone could explain to me what this is all about, if there is no way to force these "phantom" Cues to work as intended so that I don't waste any more time trying to solve it unsuccessfully.
However, I noticed some problems.
In the Dynamics section I set Soft pause duration but only a quarter (maybe even less) of the Cues respond to this function. Then, the same Cues that do not respond to Soft pause duration - don't respond neither to the Animation speed value, too.
Such Cues run at the same speed regardless of the animation speed value, only they stop when the Animation speed value is 0.
I am unable to force them to slow down or speed up beyond the default Cue speed.
I noticed another interesting thing - the same Cues that in Live Control will not respond to the Animation speed value - as soon as I open the Shape editor, Advanced image synthesizer or Edit Frame/Animation (depending on the type of Cue) - at the same moment the Animation speed control are re-established, everything go perfect (?!)
To repeat, some other Cues behave quite normally in Live mode as well.
I don't know if this is some software error in my system or it is simply impossible to set the vast majority of Cues to respond smoothly to the Animation speed in Quick Show.
Given that I spent a lot of time setting up a proper Quick Show setup for my needs, I would be very grateful if someone could explain to me what this is all about, if there is no way to force these "phantom" Cues to work as intended so that I don't waste any more time trying to solve it unsuccessfully.
