select more zone's @ image properties

Discussion in 'LivePRO' started by liquid-sky, Nov 8, 2011.

  1. liquid-sky

    liquid-sky New Member

    when i make a key effect position during 2seconds and from
    begin to mid (1sec) i program position x from left to right move and from mid to end (1sec) the same move then i have over 2 sec two times teh same move... when i have to same or differtent frames (frame 1 = line / frame 2 = circle) and i program the animation duration over 2 sec (1sec / frame) i will become the effect that you see on the picture...
    and if you mirror some zones than you get more different ways to move with the projectors... i hope that this will be possible :eek:
     

    Attached Files:

  2. Cyberb0b

    Cyberb0b Well-Known Member

    can you rephrase?

    I dont understand the question.
     
  3. liquid-sky

    liquid-sky New Member

    zones

    it would be nice if you could select all zones in "image properties" window in each frame. instead of only a select zone per frame.

    best regards Joeri
     
  4. aly

    aly Well-Known Member

    One CUE (image) can have one or more zones.
    Zones can't dinamically change when running in Live mode.
    If you want this effect as on the picture, you must
    - use Showtime (or QuickShow)
    or
    - make two cues in LivePro. One cue for inner projectors and one cue for outter projectors. Then start them at the same time...
     

Share This Page