TTL

Discussion in 'The Lounge' started by jsk, Dec 13, 2008.

  1. jsk

    jsk Active Member

    Hello,
    I have a laser with an input for TTL, from 1 to 200 Hz. Is this enough, do I damage my laser if I run it on Pangolin. Thank's.
     
  2. Pangolin

    Pangolin Staff Member

    I guess you mean that the laser modultion itself is TTL? If this si the case, then there should not be a problem to run it with LD2000, however since the upper frequency is only 200Hz, it could be that the projected image quality will not be very high.

    Most lasers have TTL modulation capability of 10kHz or more.

    Best regards,

    William Benner
     
  3. jsk

    jsk Active Member

    Thank's
    from the speciafications I can give you this...
    Operation Mode CW
    TTL Modulation 1 input, 1-200 Hz
    Transverse Mode TEM00
    sorry for my poor english and my knowledge !
     
  4. Pangolin

    Pangolin Staff Member

    It's pretty hard for me to imagine a laser whose modulation only extends to 200Hz, especially for TTL modulation. Maybe it is supposed to be 200kHz or 20kHz, either of which would work fine.

    Best regards,

    William Benner
     

Share This Page