adrem tc1 don't work in beyond?

Discussion in 'Lasershow Designer BEYOND' started by lorenzopompei, Mar 17, 2016.

  1. lorenzopompei

    lorenzopompei Active Member

    hello everyone,
    I have a reader smpte Adrem tc1, but is not detected by Beyond, the TC2000 works well, the Aquila is ok, but the Adrem don't work, in Ld 2000 works correctly.
    has anyone had any experience about Adrem?
    tanks
    Lorenzo
     
  2. ENOT

    ENOT Software Developer Staff Member

    Hi Lorenzo,

    If Adrem`s device works as TC2000 then it should work. If this device use other protocol then yes, it should not work. Software can work with hardware only when protocol is known.

    if Adrem device is MIDI based device with MTC then it should work well. I use one of Adrem timecode readers, as SMPTE to MTC converter. I used it many times during development, no problem. Such devices must be cofigured as MIDI device.

    Best Regards,
    Alexey.
     
  3. lorenzopompei

    lorenzopompei Active Member

    tank you Alexey, in Mtc work good
     

Share This Page