Hi there, this is probably my first post.
I was wondering if it is possible to do some advanced stuff then only calling commands?
As example..
I want to stop the laseroutput when my intensity slider is at 0% on the midi table or software. I know how to write the script but I cant think of any how to figure it out with these commands, I would write it like this.
if (Masterintensity == 0){
DisableLaserOutput
else
EnableLaserOutput
}
Although if statements works, but I don't ether know what I can use with it everything gives me a error except:
if (1 = 2 ){
}
The reason I want to mute the output when there's nothing going on, is because I'm facing problems over a time that my scanners goes into safety, to protect the galvo's and internally puts it on low settings, so only 2kpps would be the max..
I'm using the scanners DT40pro, with Beyond 1.60-517, scanning on max angle at 20~25kpps, FB3.
Got any tips or do I have to do this in the hardware manually way?
Thanks.
I was wondering if it is possible to do some advanced stuff then only calling commands?
As example..
I want to stop the laseroutput when my intensity slider is at 0% on the midi table or software. I know how to write the script but I cant think of any how to figure it out with these commands, I would write it like this.
if (Masterintensity == 0){
DisableLaserOutput
else
EnableLaserOutput
}
Although if statements works, but I don't ether know what I can use with it everything gives me a error except:
if (1 = 2 ){
}
The reason I want to mute the output when there's nothing going on, is because I'm facing problems over a time that my scanners goes into safety, to protect the galvo's and internally puts it on low settings, so only 2kpps would be the max..
I'm using the scanners DT40pro, with Beyond 1.60-517, scanning on max angle at 20~25kpps, FB3.
Got any tips or do I have to do this in the hardware manually way?
Thanks.