audience scanning + projection zones brightness

Discussion in 'Laser Safety' started by lasershows.at, Apr 14, 2004.

  1. lasershows.at

    lasershows.at Member

    Hi all,

    is there a way to reduce "brightness" only in the lower half of a projection zone?
    Ideally it should have a linear decrease of brightness!

    It would be a good way to get full laser power above the audience and low laser power when scanning the audience.

    greetings
    Tom
     
  2. imported_John

    imported_John Member

    Hi Tom,

    go to the projection zones setup window and select "beam attenuation map" (Stahlabschw
     

Share This Page