Auto connect points in Advanced Frame Editor

Discussion in 'Lasershow Designer BEYOND' started by absolom7691, Jun 17, 2020.

  1. absolom7691

    absolom7691 Member

    Hello all,

    I have an object in the advance frame editor that I am trying to "extrude". The points are pretty simple and my solution was to duplicate the object and move the copy behind the original. To extrude, I tried to draw lines from the points on the original object to matching points on the duplicate. I am finding it very difficult. When I rotate the view to see both sets of points better, drawing a line between the points doesn't connect them. Rather, it draws a line somewhere in the 3D space at some tangent. It only appears connected at that view perspective. If I rotate the view, it's clear that the line is not actually connecting the two points.

    So the simple question is: Is there a way to select two points and have a line auto connect them, regardless of where the points are in 3D space?

    Thank you!
     
  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    Hi Absolom, Extrude is only available in BEYOND 3D. So the function you request is not available.