BEYOND add qm after fb3

Discussion in 'Lasershow Designer BEYOND' started by michelrietveld, Jan 23, 2015.

  1. michelrietveld

    michelrietveld Active Member

    Hi, just setup my new notebook with beyond and fb3, now i like to add my qm200 but am unable to find out how to do this.
    installed ld2000 thought this would allow beyond to add the projector but i only see my fb3, which steps to take or do i have to install ld2000 first and then beyond to be able to use both qm and fb3 together?

    Michel
     
  2. michelrietveld

    michelrietveld Active Member

    solved

    Go into Settings>Configuration in Beyond and on the Controllers tab make sure "Enable QM2000 controllers" is checked. If it wasn't, check it and then close and restart Beyond. My guess is because you installed the LD2000 after Beyond it might not have checked it.
     

Share This Page