Beyond dmx setting

Discussion in 'Lasershow Designer BEYOND' started by thelaserxtreme, Aug 27, 2013.

  1. thelaserxtreme

    thelaserxtreme New Member

    Hi!
    I want to use the smoke machine using the dmx through QM2000 and Beyond but I can not set the output. Is it possible? How can I do? How do I set the settings?
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    Currently you cannot use the DMX/MIDI connector on the QM2000 from within BEYOND. You can only do DMX out in BEYOND via ArtNET, ENTTEC DMX USB Pro, and possibly OSC (someone correct me if I am wrong on the OSC).

    Thank being said, as a workaround, you can use the DMX/MIDI out connector on the QM2000 WHILE running BEYOND; you will run the QM24.EXE (located in the LD2000 folder). This will open a small virtual DMX console which uses the QM2000 DMX/MIDI connector that will function while BEYOND is using the ILDA out of the QM2000.
     

Share This Page