Beyond SLE 2.0 Artnet using Universes 2,3, or 4

Discussion in 'Lasershow Designer BEYOND' started by JTRjammer, Sep 25, 2015.

  1. JTRjammer

    JTRjammer New Member

    I have Beyond 2.0 SLE 699 B and cannot get it to respond to Artnet unless Artnet input is set to Universe 1. If I choose Universe 2,3, or 4 and look at the input monitor I can see the ARTNET/DMX activity coming into Beyond, but no response. If I switch it back to Universe 1 it picks up works fine. Appreciate any thoughts or input on something I may have overlooked. I am sending the Artnet broadcast from the same PC, but I have tried this from a separate PC with same results.
     
  2. ENOT

    ENOT Software Developer Staff Member

    Hi!

    There are 2 parts - communication and reaction. it looks like your communication part work OK, and you see the data in DMX monitor of BEYOND.

    So, there is a question with reaction. There are a few places where you can test the reaction - DMX to PangoScript, "Channels" at Channels tab on the right, "Inputs" in Effects, Abstracts, Synth.

    Anyway, I re-read you question, and possibly I misunderstood. In all cases, as a first step, ensure that you see correct data in DMX Monitor. After that you may check the reaction.

    Regards,
    Alexey
     

Share This Page