Change Artnet Output Interface

Discussion in 'Lasershow Designer BEYOND' started by Helyx, Jan 12, 2016.

  1. Helyx

    Helyx Active Member

    Hello everyone,

    is it possible to change the network interface to which the artnet output is routed?
    I have two network adaptors and the output is on the wrong one.

    Cheers

    PS.: I'm talking about 699 B
     
  2. ENOT

    ENOT Software Developer Staff Member

    it is not possible to change that in 699B. Same situation with 2.1 (so far). We are planing rework of ArtNet subsystem, the most possibly it will touch OSC too. It already in TODO list.

    Best Regards,
    Alexey
     

Share This Page