chase across multiple projector (zones)

Discussion in 'Lasershow Designer BEYOND' started by michelrietveld, Oct 23, 2013.

  1. michelrietveld

    michelrietveld Active Member

    Great online training, realy apreciated.

    Question, if i have two or more projectors and they have zone settings to make for example 4 squares next to each other and i want to make a circle start in the first zone and move over to the next until last zone.

    How would i do this?

    Michel
     
  2. Bob@Pangolin

    [email protected] Staff Member

    Set up 4 projectors, for example on zone 1 to 4.
    So the 4 projectors mach up physically.

    Next take zone 5, put it on an non existing projector,
    Open the "also to" tab,

    Enable this, add on the left side zone 1 to 4.
    And separate the area so they all mach up as 1 large field.
    So click zone1, set it to only act as the upper left corner.
    Click on zone 2, do the upper right corner,
    Click zone 3, do the left bottom corner..
    And so on...

    Now you can send an cue to zone 5 and zone 1 till 4 will project the image.
     

Share This Page