Couple of questions??

[Sam-S]

Hi,

I am going threw my software every time a get some free time and have come up with a few questions.

1. How do I get a CW beam at full power out of the software for measuring power I did read this somewhere before but can't find the thread now.

2. What is the best scan speed for beam shows I have 40kpps scanners in my projector should I set the ilda test up with 30kpps then bring the scan speed down after its all tuned??

3. How do I know what angle I am projecting at?? I see the setting to make the projection area bigger but can't work out what angle it is as it goes up in percentage not degrees?

Hope someone can help with this.

-@

 

[Aaron@Pangolin]

1.) Watch the QuickShow Tutorial chapter 7. This deals with QuickTarget beams and will show you something you can use to get the power measurements you want.

2.) 30k is what most shows are programmed for since 30k is the ILDA standard.

3.) We have a page on our website that explains scan angles and shows several ways to calculate the scan angle of your projector. http://www.pangolin.com/userhelp/scanangles.htm

 

[Sam-S]

1.) Watch the QuickShow Tutorial chapter 7. This deals with QuickTarget beams and will show you something you can use to get the power measurements you want.

2.) 30k is what most shows are programmed for since 30k is the ILDA standard.

3.) We have a page on our website that explains scan angles and shows several ways to calculate the scan angle of your projector. http://www.pangolin.com/userhelp/scanangles.htm

Excellent thank you for your help with this -@