Different scanrate in each zone

Discussion in 'Lasershow Designer 2000' started by Insanity, Feb 6, 2008.

  1. Insanity

    Insanity Member

    Is it possible to alter and save the scanrate on a per zone basis?

    For example, set the scanrate for main graphics to 25k and then set the scanrate for atmospheric effects to 30k and then save this configuration for each time the software starts?.

    Thanks
    Mark
     
  2. Pangolin

    Pangolin Staff Member

    Scan rates are not done on a per-zone basis, but instead can be assigned on a per-frame basis or per-timeline basis. Scan rates can also be affected using a "Scan rate" effect.

    Best regards,

    William Benner
     

Share This Page