ENTTEC DMXIS - 512-Ch USB DMX Interface with quickshow ??

Discussion in 'Lasershow Designer QuickShow' started by b52productions, Jan 5, 2017.

  1. looking for a different interface than the
    ENTTEC DMX USB PRO

    or maybe the newer model

    DMX USB Pro MK2.

    i currently use quickshow and plan to use ableton with dmxis, but plan to ugradeto beyond.

    any suggestions

    thanks
     
  2. Bob@Pangolin

    [email protected] Staff Member

    The DMXIS is not supported.
    The DMX USB Pro can work for 1 universe after configuration that is.
     
  3. it has been discontinued to the newer mk2 as i have tried to order from you.. will this newer model work.

    i switched to grandMa.2pc for dmx control, i have already orderd the edmx2pro for free universe using art-net

    -- removed link --
     
    Last edited: Jan 6, 2017
  4. Bob@Pangolin

    [email protected] Staff Member

    The Enttec pro MK2 will work after reconfiguration with the tool available from the Enttec website.
    You need to place it in serial mode. Then you can use 1 of the 2 DMX universes for QuickShow or BEYOND. DMX king never tested!!!

    DMX king is not Enttec!
     
  5. understood. and thanks for the info.. i will end up with beyond and grandma2 someday but will have to piece quickshow in there for now somehow lol
     
  6. Bob@Pangolin

    [email protected] Staff Member

    If you upgrade to BEYOND, focus on art-net , especially in combination with GrandMa.
    Check for an Enttec ODE or similar product.
     

Share This Page