Enttec USB MkII doesn't work in Beyond

Discussion in 'Lasershow Designer BEYOND' started by AlexJ, Nov 26, 2013.

  1. AlexJ

    AlexJ Member

    I passed instalation procedure and installed old driver but no response. At the same time, a fixture responds with DMX-Pro Manager. Of coarse, I have tried to test port 3 connection and everything looks fine, LED power blinking white/green at DMX 1 output but no action. Any idea?
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    I recently tested the MK2 in BEYOND with no issues except that I had to install the older MK1 drivers. If you have done that then you should be good to go.
     

Share This Page