Flash Solo behaviour

[lordGoldemort]

Not sure if this is a bug, but if I have 2 projectors P1 and P2, each with their own zone Z1 and Z2 respectively; I run a normal cue on them both, then select Z1 and trigger a cue that has "Flash Solo" mode, I sort of expect it to solo on P1 only, but P2 stops what it's doing as well as P1 (though nothing shows) until I release. Is that correct? Shouldn't "solo" observe the selected zones?

 

[Turgay Acar]

You should use the multi cue feature

 

[lordGoldemort]

You should use the multi cue feature

So in Multi-Cue mode, only the selected zones are solo-ed when a cue is set to Flash Solo?

My issue with Multi-Cue is that it requires several cues to be selected; if I want them to start simultaneously then I need to write PangoScript - which I can, but it seems like a complicated solution for a common use case.

 

[Turgay Acar]

If you want to give different flash-solo features to each cue, right click + cue properties and then change the start mode, you will not need to use an extra mode. You can use toggle or solo if you wish.



,


I think this process will be more comfortable for you. You may not have any work to do with Multi-Cue, but unfortunately you will still need multi-cue to run 2 or more cues.