Gordy is a DJ
New Member
Hi all,
New to this so bear with me.
Have a Kam laserscan 1000 3d on which I am trying to project text using quickshow. Have also tried lw cs1000 rgb which demonstrates exactly the same issues.
Text is appearing but cannot stop the flickering which is very much like a strobe. Have been through the help videos to little avail.
Scan rate is 30,000 but even the shortest, most simple text will not stop flickering.
Any ideas what I can do?
Thanks in advance.
New to this so bear with me.
Have a Kam laserscan 1000 3d on which I am trying to project text using quickshow. Have also tried lw cs1000 rgb which demonstrates exactly the same issues.
Text is appearing but cannot stop the flickering which is very much like a strobe. Have been through the help videos to little avail.
Scan rate is 30,000 but even the shortest, most simple text will not stop flickering.
Any ideas what I can do?
Thanks in advance.