Frames (new) Logo problem

J

Joyluca

New Member
Hi,
i have a big problem.
i need to show a logo. i have the .eps converted into windows metafile. i import in a new cue inside a Frames but whne i enable the laser output the lines becomes spline and the logo is right only if i lower the scan rate at the minimum.. but this make all flicker.
someone can help me? thank you so much
 
It sounds like your logo is too complex for your scanners. Send me the logo (to my screen name) and I can verify this for you.
 
You must log in or register to reply here.
Back
Top