Geometric correction with TouchOSC

Discussion in 'Lasershow Designer BEYOND' started by Joss, Nov 7, 2013.

  1. Joss

    Joss Member

    Hello,

    I was wondering if it would possible to control "goemetric correction" through TouchOSC. It would make things so much easier, espacialy when the computer is not right in front of the projection. Or maybe there is another method that keeps you from getting up from where the computer is to the front of the projection everytime there is a modification to make.

    Thank you.
     
  2. ENOT

    ENOT Software Developer Staff Member

    Hi Joss,

    During testing I used another OSC application - Lemur. In attachment layout for zone setup, demo/test of multi-touch gateway, and demo/test of OSC to DMX and OSC to Beams.

    Best Regards,

    Alexey.
     

    Attached Files:

Share This Page