Get rid of the seam in ellipses...

Discussion in 'Lasershow Designer QuickShow' started by Kalle Werning, Jul 21, 2023.

  1. Kalle Werning

    Kalle Werning New Member

    Hey!

    I'm trying to get rid of the stripe, which occurs at 3 o' clock in circles. It doesn't matter what I'm doing, it's always there. Even with the paramectric images, where you can set, that Quickshow should draw a 101% closed circle, then you see the overlapping part. Is it really not possible to draw a seamless circle in Quickshow? :( I can't believe that...

    Greetings from Germany
    Kalle
     
    Kalle Werning, Jul 21, 2023
    #1
  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    I think you need to play with the blanking points in your projector. Every projector has its own optimal settings.
     

    Attached Files:

    Bob@Pangolin, Jul 24, 2023
    #2
  3. Kalle Werning

    Kalle Werning New Member

    I will give it a try... But I don't think it will help. It really appears on every projector and every circle-cue I used so far. Nobody else has this issues? :eek:
     
    Kalle Werning, Jul 25, 2023
    #3