How to make chases

Discussion in 'Lasershow Designer QuickShow' started by SHavok, May 21, 2014.

  1. SHavok

    SHavok New Member

    Hi All,

    I recently purchased a second FB3 so I can have separate control of my lasers.

    I currently use 1 center projector on one FB3, and now 1 on each side sharing a FB3, but one is hardwired to invert image)

    After searching the forums, I figured out how to select which zone a cue is played on in the cue settings, But I can not figure out how to make a simple chase (zones switching on and off within the same cue) Can someone please explain how this can be done?

    Thanks.
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    I suspect most of the "chases" you are seeing were done in BEYOND.

    The only way I am aware you could do it in QuickShow is by making a small timeline animation using multiple cues, each set to go to a different zone, staggered on a timeline to simulate a "chase"; then drag that small timeline show to a cue for future use.
     

Share This Page