i need your help

Discussion in 'Lasershow Designer BEYOND' started by slava, Dec 11, 2014.

  1. slava

    slava New Member

    Hello. I need professional help to set up a laser or configuring the software. My problem is that when I play back a laser show, the picture is very blinks. what could be the problem? I can send the video. Equipment: 2 laser "SKYRAG-7 MK3" QM2000 PCI board 256mb "intro"
     
  2. LVR

    LVR Member

    Слава, Добрый День!

    пишите в личку, поможем
     
  3. Aaron@Pangolin

    [email protected] Staff Member

    Please send me a video of what you are seeing. I suspect your scan rate is too low, you are sending the laser content to the laser more than once (a projection zone issue) or you are sending a laser frame that is too complex.
     

Share This Page