Installing Quickshow on a second computer

Discussion in 'Lasershow Designer QuickShow' started by djpaul, Nov 27, 2014.

  1. djpaul

    djpaul Member

    Hi

    I bought Quickshow at the beginning of the year and now want to install it on another pc in the house to make shows at home
    After installing the software it comes up as demo version and now asks me for a bit map code ...The problem is i cant remember the code that was sent to me and i dont use the same email address as i did when i first git the code...
    Is it possible to get the code from my other pc and put it in the new pc i have just installed it on ...Or do i have to email Pangolin to get the code again

    Desparate to get this sorted asap

    Regards Paul
    07787 392410
     
  2. mtregael

    mtregael Member

    You just have to plug the usb interface on your home pc and launch quickshow.

    It will be unlocked forever. The next time you'll use it, you won't need the interface ;)

    It's what i did to use my laptop to prepare my shows.
     
  3. djpaul

    djpaul Member

    Hi

    Thanks for the reply
    No ...The software wants a Bitmap file

    I'm sure i received from someone at Pangolin through email when i first installed the software on the other computer....

    I had sent Aaron a PM but still had no reply :mad:

    Paul
     
  4. bikeraper

    bikeraper Active Member

    Delete ist and make a new installation. Then start it with the FB3 on USB. I did that about six month ago and it worked perfect.
     
  5. djpaul

    djpaul Member

Share This Page