Is this possible?

Discussion in 'Lasershow Designer QuickShow' started by GAZ., Feb 12, 2014.

  1. GAZ.

    GAZ. New Member

    Just bought quickshow on recommendation to use with my Kam laserscan 10003D.
    Theres a couple of the built in patterns on the laserscan that I like such as the 3D patterns and a couple of others .Is there any way of getting those patterns into quickshow?
     
  2. Bob@Pangolin

    [email protected] Staff Member

    If you have them as .ILD file, you can import them into a cue.

    If its in the hardware of the laser, and you can't retrieve the data, its hard to retrieve them, NOT impossible, but not something for the unexperienced :) .
     

Share This Page