I am trying to get my Beyond 5.1 installation to work with a 3rd party laser with a FB4 installed. The issue I run into is that when I select an animation only a portion of the animation but when I go into the projector settings the animation shows properly. Am I missing something? the animations show fine on my kvants.
Laser newbie question
- Thread starter Kcamrac
- Start date
Bob@Pangolin
Staff member
Are you speaking about executing the frames from FB4 or through ether QuickShow or BEYOND?
Bob@Pangolin
Staff member
try to disconnect the midi controller and make sure the visible points slider is set to 100%