Laser output preview in perspective?

[Lubomir]

Hello,

new to Quickshow. I just watched a tutorial where the preview of the laser output was "in 3D space" - I can see the effect of beams and sheets in perspective whereas in my case I can only see sheets as lines and beams as dots. Is there a setting in QS for this? See screenshots - one is from the YT video and the other is what I see.
QS version 5.5.0 build 1924.

Thanks in advance!

 

[Bob@Pangolin]

Open your projection zones, select the projection zone, and make changes on the preview tab. There is where you can adjust this.

 

[Lubomir]

Open your projection zones, select the projection zone, and make changes on the preview tab. There is where you can adjust this.

Thanks!

 

[Lubomir]

Open your projection zones, select the projection zone, and make changes on the preview tab. There is where you can adjust this.

Maybe one more interface related question. I checked "show 4 lines" in the bottom right corner of the window but now I can't uncheck it. See attached. Thanks?

 

[Bob@Pangolin]

Its fps or points, switch to fps and it should be gone.

 

[Lubomir]

Its fps or points, switch to fps and it should be gone.

I already tried switching to FPS but it doesn't work. 4-lines are still there ...

 

[ENOT]

Hi Guys.

4th line - already found & fixed.

Switch between FPS and Points. Now is switch between FPS/Points and Points. Mostly because people think "I have low FPS, it means I have a problem". No you dont, you have some number of points, and defined projectors KPPS, and KPPS/Points give you FPS.

Anyway, there will be sw update, probably in a few weeks. For now - just ignore this "4 lines".