Laser preview with dmx in

Discussion in 'Lasershow Designer BEYOND' started by myanezt, Nov 13, 2015.

  1. myanezt

    myanezt Member

    Hello,

    When configure Enttec to control cues, there is not laser preview on the right windows? Is that normal?
     
  2. ENOT

    ENOT Software Developer Staff Member

    Hi

    This is normal in general meaning. You should see active cue in the grid and you should see movement of Live Control tab sliders (Master). The default mapping use Master Live Control, check sliders state - visible points and brightness.

    Regards,
    Alexey
     
  3. myanezt

    myanezt Member

    Thanks Alexey

    Last question, the cue DMX assignment is limited to 15 pages in QuickShow? Assuming that each page use 15 levels.. what happen if I have more pages?
     
  4. ENOT

    ENOT Software Developer Staff Member

    in QS mapping work linearly, pages cannot be selected.

    Alexey.
     

Share This Page