LD2000 on USB

Discussion in 'Lasershow Designer 2000' started by ALF666, Apr 17, 2017.

  1. ALF666

    ALF666 Member

    Is there any way to use some kind of adapter to use LD2000 cards with laptop not full ATX computer ??
     
  2. ENOT

    ENOT Software Developer Staff Member

    QM - NET
     
    togepisq likes this.
  3. ALF666

    ALF666 Member

    That is obvious answer...but if my "QM2000 board is under serial number 3400 it will not be able to work in a .NET configuration" so I'm looking for any alternatives. I cannot find PCI to USB adapter but found PCI-ex to USB and PCI to PCI-ex but do not know it will work through 2 adapters... any other idea than QM - NET ??
     
  4. ENOT

    ENOT Software Developer Staff Member

    OK, I understand, sorry. No, no other ideas. Good luck with search.
     
  5. Hektek

    Hektek Beta Tester

    I happen to have a vintage Thinkpad with a small docking station that a QM2000 card will work in. You'll be using XP, but if you are just running Showtime it works, and is more portable than a desktop PC.
     
  6. ALF666

    ALF666 Member

    Super ... could you write somethintg about this docking station ? model of it or model of thinkpad to look for it's accesories ??
     
  7. Hektek

    Hektek Beta Tester

    It's a Think Pad Type 2628 and the dock is a Type 2631.
    http://www.thinkwiki.org/wiki/ThinkPad_Dock

    It might actually be running Win98 instead of XP. I've not booted it up in years.
    I'd be willing to sell it if you want to go this route. Although I would suggest you are better off using modern equipment.
     

Share This Page