Led on the QM.net OEM

R

Ruud

Member
Hello there college laserist. I have a question about the QM.Net OEM version. The UTP connector has 2 LED's that will tell you if you have connection. Now I would like to link them to the back of my laserprojector so that I can see if the QM.net receives data. How can I link the LED from the board. And what voltages can I use.
I hope some one knows an nice solution.

Best regards Ruud from Lightning Productions :rolleyes:
 
Dear Ruud,

I recommend you contact us directly using our contact form at www.pangolin.com/contact

There is a connector on the QM2000.NET board that will allow you to connect LEDs and thus get the status. We have a diagram that we can send you by email if you contact us.

Best regards,

William Benner
 
You must log in or register to reply here.
Back
Top