Chris Priest
Active Member
Morning all,
I know the subject of linking two projectors to one card has been discussed and I'm happy about building the splitter, I do have a question tho and forgive if it's been answered before.
I have two projectors, one whitelight and one DPSS. I need to link both projectors to the one QM2000 card.
The question is.. According to the docs, I should tie the colour neg outputs to ground and use one of the RGB lines to modulate the DPSS, however, would this not cause problems for the PCAOM in the whitelight? Instead of tieing them to ground, is it possible to use the intensity line instead? (assuming my DPSS intensity line works, waiting for clarification on that) Otherwise my only option is a TTL blanking input +5 off 0v on No fading
Can anyone give me any advice/point me in the right direction etc?
Many thanks
Chris
I know the subject of linking two projectors to one card has been discussed and I'm happy about building the splitter, I do have a question tho and forgive if it's been answered before.
I have two projectors, one whitelight and one DPSS. I need to link both projectors to the one QM2000 card.
The question is.. According to the docs, I should tie the colour neg outputs to ground and use one of the RGB lines to modulate the DPSS, however, would this not cause problems for the PCAOM in the whitelight? Instead of tieing them to ground, is it possible to use the intensity line instead? (assuming my DPSS intensity line works, waiting for clarification on that) Otherwise my only option is a TTL blanking input +5 off 0v on No fading
Can anyone give me any advice/point me in the right direction etc?
Many thanks
Chris