LiveProUSB

C

Cruch

Well-Known Member
When I tries to run the LivePro USB, I get the FB3-SE Service Center.
Embedded firmware 6,52.
Board: FB3-SE, #1
State: Connected
Firmware: 0,00
Communication failure (No ping response)

Any ideas?
Many times the FB3 is connected, then disconnected again.
It happends many times. On different computers also.

regards
 
Hi Cruch...

If you already downloaded the last version of Quickshow and checked if you have the latest firmware you better can email support.

Btw.. Do you have a new laser again? :)
 
Cyberb0b,
I got the 7.12 firmware version. It work with QS but the LivePro Usb is better I think? I can use sms2laser on LivePro.

I got the 1.8watt green laser + and a small 300mw green.
I was thinking of adding 2Watt 445nm and 642nm or 637nm ;)
Still reading alot at PL, it has been 2 years or so since I did lasers...
 
Problem solved by downloading a new version of LivePro USB from Pangolin software updates page.
 
You must log in or register to reply here.
Back
Top