Masking in Beyond

Discussion in 'Lasershow Designer BEYOND' started by digiassn, Dec 30, 2013.

  1. digiassn

    digiassn Active Member

    I'm trying to figure out how to do masking in Beyond. This was fairly easy in Showtime, but in Beyond I don't see where this can be done outside of Beyond3D. How can this be done?
     
  2. ENOT

    ENOT Software Developer Staff Member

    BEYOND offer same functionality as ST2000. Masking settings can be found at Event tab on the right side of main window, in the timeline mode. The "Masking" panel at bottom side of the page.
     

Share This Page