Memory upgrade

Discussion in 'QM2000 series of products' started by danyV, Dec 29, 2006.

  1. danyV

    danyV New Member


    We recently bought a QM2000 intro card and want to do a memory upgrade
    We bought a 512mb Kingston SDRAM PC133 cl 3 ValueRAM and replaced the original 256MB stick, but in the About window it still shows 268mb installed memory.

    What can i do to fix this problem ?

    Thanks in advance, Daniel.
  2. Helldriver

    Helldriver New Member

  3. danyV

    danyV New Member

    Thanks, i'll see if the memory i installed is single sided.
  4. danyV

    danyV New Member

    it's double sided

    could this be the problem

    i anyone from pangolin see's this please reply.

    Thank you !
  5. Pangolin

    Pangolin Staff Member

    Really, we would always recomment you purchase memory from Pangolin. In addition, if you want to use 512MB, a small modification must be done on the QM2000 board.

    By returning the board to Pangolin, we would perform the modification, update the firmware (if needed) and check the general health of the board.

    When returning the board to Pangolin, please follow the directions on this page:

    Best regards,

    William Benner
  6. Cruch

    Cruch Well-Known Member

    I see it is singlesided sdram memory that is used, but is it 100mhz or 133mhz ?
  7. Pangolin

    Pangolin Staff Member

    PC100 or PC133 memory will work fine. In fact, even PC66 memory will work fine...

    Best regards,

    William Benner
  8. Cruch

    Cruch Well-Known Member

    ok! Thats good to hear :)
    Another question: I will receive an intro board soon with serial: 3845 and I got 512MB kingston memory singlesided. I guess I need to send the intro and the kingston memory to you for the memoryupgrade?
    Read something modification is needed on the LD2000 card. If I want to upgrade the Pro card, I will also send this in also? Serial 7197