Missing Zone/preview window

Discussion in 'Lasershow Designer BEYOND' started by dennisthemenace, Feb 15, 2014.

  1. dennisthemenace

    dennisthemenace Well-Known Member

    Hello fello laserists :)
    Been a while since i last opened up beyond now due to broken projector, however i upgraded with the new installer and notices that the zone selection window that used to be in the upper right is missing. Has this been removed in the later version or is it just me?

    Cheers


    Skärmavbild 2014-02-15 kl. 18.24.55.png
     
    Last edited: Feb 15, 2014
  2. ENOT

    ENOT Software Developer Staff Member

    Hi Dennis,

    The splitter is stop on top, you should see it above the tabs. If you can not move the splitter, then open BEYOND.INI and delete this line: pnTopPreviewHeight=...
    or set desired height of the window.

    Cheers,

    Alexey
     
  3. dennisthemenace

    dennisthemenace Well-Known Member

    Thanks Alexey :) that did the trick :N

    Lots of new stuff since i last updated it, looking forward to dig into it again :)
     
    Last edited: Feb 15, 2014

Share This Page