mixed modulation

P

Prism

Member
We are looking to use build a "mixed-modulation" projector (argon beam through PCAOM then combined with a red diode that is directly modulated), but I'm concerned that the color blanking won't match for the two beams. Is there any way to compensate for this? Are there any plans to the update LD2000 palette controls to handle something like this?

Thanks,

-Prism
 
Hi,

i use the same. You connect the Diode to the red channel, the blanking goes only to PCAOM.
You have 0-5V input ? With diode ?

You can make automatic color setup and it works.
But the most driver of diode are not linear, you can now adjust fine with manual edit of the color balance.

Best regards from Germany
Richard

[ October 01, 2003, 04:29 AM: Message edited by: Richi ]
 
You must log in or register to reply here.
Back
Top