Multiple projectors over DMX?

Discussion in 'Lasershow Designer QuickShow' started by AlexJ, Nov 29, 2012.

  1. AlexJ

    AlexJ Member

    Hello guys,

    I have a strange situation - a client should get 20 RGB projectors for the show but I have only three FB3-QS units. :confused: Is there any way to control all that projectors as DMX devices from QS with Enttec USB Pro? All projectors are equipped with DMX. All suggestions are welcome and appreciated!

    Thank you! :)
     
  2. vIQleS

    vIQleS Active Member

  3. vIQleS

    vIQleS Active Member

    Or unless I'm not understanding your question - are you asking about how to set the projectors up / DMX basics?
     
  4. vIQleS

    vIQleS Active Member

    Oh - and for a suggestion:

    If you have Lightfactory (or something similar) try it the other way round.

    You can control QS from LF using DMX: setup your lasers as fixtures in LF, do the same for QS (,smokes, hazers etc), and then run the whole thing from LF.

    I'd use either effects runners (for "random" access) or setup a cue list (for a sequence)*. (Depending on the type of show...)

    * or a mix of both
     
  5. AlexJ

    AlexJ Member

    I'd rather use QS for cue triggering, no need for DMX in function.
     

Share This Page