Not recognised ENTTEC DMX USB PRO

Discussion in 'Lasershow Designer QuickShow' started by guymych, Jun 16, 2017.

  1. guymych

    guymych New Member

    Hi all,
    I been tried to resolved the problem of dmx usb pro but still nothing, My problem is the when i click on the Dmx setting its says that: quickshow is not able to detect any COM port on your pc...... Please Install the ENTTEC DMX USB PRO device and try this menu again.

    The this is that on the pro manager its detect the device and the output and input are good the firmware is 1.44 and i even change the COM port still not working.

    Hope that some can help me with this..
  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    Do you have the Enttec DMX pro MK2? If so, you need to download the application from the enttec website to set it in serial mode.
  3. Thomas Otto

    Thomas Otto New Member

    i have also problems with enttec, did you have any news?