odd output issue

Discussion in 'Lasershow Designer BEYOND' started by Kent Rhodes, Nov 11, 2020.

  1. Kent Rhodes

    Kent Rhodes Member

  2. Igor Strakhov

    Igor Strakhov Staff Member

    Hi, Kent Rhodes!
    Check the effects tab in the Projection Zones.
    Most likely there is some effect :)
    upload_2020-11-12_20-37-47.png
     
  3. Kent Rhodes

    Kent Rhodes Member

    Once again sir you are spot on. I knew I was overlooking something - sad thing is I dont even remember adding any effects to the zone!!

    Thank you